Antenna Rotator System - RCI Boards

The RCI board has been tested with many commercial rotators. It has been designed as a Universal Rotor Interface and can be adapted to all existing rotors. In the manual, step by step installation instructions will help you setup the most common rotors models. This is possible through the use of variable resistors (trimmers) that allow you to set the optimum calibration.

Some of the most popular rotors verified to work with ARS include:

Compatible Rotators:

• Yaesu: G250, G400S, G450A, G500 & G500A (Ele), G650A, G800S, C, SDX & DXA, G1000S,C, SDX, DXA & DXC, G2000S & RC, G2800DXA, G5400, G5500, G5600, etc.
• Telex/Hy-Gain: HAM-IV, HAM-M, HAM-2, T2X, HDR-300
• Kenpro: KR-400RC, KR450XL, KR-500(Elevation), KR-600RC, KR.650XL, KR-600RC, KR600S, KR-800, KR-1000, KR-5400 & 5600 (Az&El)
• Daiwa: DR-7500 serie R and X, DR-7600 serie R and X
• ORION: 2300, ...
• CREATIVE: RC5x-3P, RC5-1, RC5-x series, ERC-51
• EMOTATOR: 1105, EV700X
• EMOTO: 1200 FXX
• Aliance: HD73
• Pro.Sis.Tel: All "B" Control Unit models and "D" (**)

Note: PST "D" Units doesn't use the RS232 interface available at this model, so the RCI-SE must be used.

If you have any other rotor not mentioned above, send me a message containing its schematic diagram and I'll answer whether it's possible to adapt ARS to it. There is a high likelihood that it will be supported with no or minor modifications.